A&S Plastic Emulsion is a premium quality acrylic-baed paint specially designed to give a luxurious smooth finish to interior masonry surfaces, brickworks and wallboards. it is a highly washable Plastic Emulsion with an added fresh lemon fragrance, its fungus resistance properties, smooth finish and long-lasting colours make it an ideal choice for interiors.
Bare Masonry Surfaces
Bare masonry surfaces should be completely dry and free from dust, dirt and grease. Use a bleach solution to treat the surface affected by fungus. Apply A&S Wall Sealer and allow thorough drying. Sand and dust off. Smoothen the surface by applying 2-3 coats of A&S Wall Putty. Sand and dust off thoroughly. Allow all surfaces to dry completely prior to painting. Avoid painting when the moisture content and alkalinity of the walls is still hight
Previously Painted Surfaces
Sound Surface:
Remove unstable paint film and loose chalk by rubbing down using abrasive paper or wire rust and dust off. Prime with A&S Wall Sealer. Fill the surface with A&S Wall Putty if necessary.
Severely Defected Surfaces:
Masonry work is recommended to repair large cracks and holes. allow to dry thoroughly. Prime with A&S Wall Sealer. Fill with A&S Wall Putty. Scuff to make smooth and dust of thoroughly.
Drying Time :Touch Dry: 15 minutes.
(Dependent on temperature and humidity)
Hard Dry:45-60 minutes.
Re-coating Interval :2-3 hours.
Theoretical Coverage :14 – 16m2 per liter per coat.
(May vary depending on the substrate conditions)
No. of Coats :3 – 4
For Optimum Results :Apply 1 Coat of A&S wall Seater before applying
A&S Plastic Emulsion
Refer to Technical Data Sheet for application and thining procedure.
.Stir well before use.
.Application can be done by brush, roller or spray.
.Thin (by volume) up to 50-70% with clean water for brush application,
20-30 & for roller application & 30-40% for air spray application.
.Clean up all equipment with water immediately after use.
.Keep out of the reach of children and away from food and drink, Do not
swallow the paint. If swallowed, seek medical advice immediately.
.Ensure good ventilation during application and drying.
.Do not breathe in vapor or sanding dust. Avoid contact with eyes and skin
When applying paint, it is advisable to wear eye protection. In case of
Contact with eyes, rinse immediately with plenty of water and seek medical
advice
.Wear protective clothing and mask white applying paint. Use soon and
water to clean the splashes from skin.
.Paint must always be stored in a cool and dry place.
.Care must be taken during transportation. Always keep container in a
secure upright position.
.Use sand to contain any spillage. Dispose off paint in accordance with the
appropriate environmental Quality Regulation.
.Do not discharge into drains or environment.
.Does not contain any added Lead, Mercury, Chromium and Cadmium
compounds.
.Chemical Safety Data Sheet available on request.A&S